2019 the TroPro trade exh…
-
Drive belts
Release Time：2016/06/12Browsing Times：1147
Drive belts is an important part of getting the X,Y,Z axis moving, Low quality belts would age fast after high speed moving, this will result a bad impact on the cutting engraving effect. Thunder L...
-
Exhaust system
Release Time：2016/06/12Browsing Times：1287
Laser cutting and engraving job would produce many fog and dust on wood laser cutting machine table, thus we need to use a exhausting system to expel the fog and dust out in time to ensure the work...
-
The strong machine case
Release Time：2016/06/12Browsing Times：1155
A heavy strong machine case of fabric laser cutting machine can resist the machine shaking, especially when the machine work in higher speed. This is good for us to improve the laser machine perfor...
-
Air assist
Release Time：2016/06/12Browsing Times：1702
The air assist of co2 laser engraving machine is used for blowing air to prevent the material being burned while cutting. When laser cutting some kinds of material, it would produce sparks which...
-
Standard laser head
Release Time：2016/06/12Browsing Times：1358
Standard laser head is the laser head of the laser cutting machine that installed a 2" focus lens, we also call it 2" laser head. It is good enough to engrave letters and most simple patterns, and ...
-
Large buffer memory
Release Time：2016/06/12Browsing Times：1023
Once you load the file to the laser engraver machine from computer, the file would be saved in the memory of the laser engraver machine. Then if you need to process the same file next time, you can...
-
Free Home position
Release Time：2016/06/12Browsing Times：1008
If you don’t want to start the work from the original point when you get on laser cutting or laser engraver, but from another positions to start, you can freely change the starting position by the ...
-
USB disk interface
Release Time：2016/06/12Browsing Times：1184
If there’s no computer in the place you put the laser machine, or you have several laser cutting machines but only one computer and the USB cable is not long enough, how to load the file to the las...
